The water bill arrives and the consumption is higher than normal. In looking at the bill you realize it's winter time, your water consumption is down, but the bill says it is up as if its summer when your water consumption is higher. Then it hits you garbage disposal a water leak! At some point almost all homeowners run into this problem.
Water leak detectors are alarms that alert you of leaks. They do not stop the water leak from happening. They also do not stop the leak after it happens or turn off the water line repair valve. You will still need to turn off the water valve yourself and contact a Utah plumber to come check out the plumbing issue.
After you have the stems out you should be able to find the washer on the "inside" end. If it is nicked, torn or brittle it is likely the cause of your drip. Even if it looks brand new, go ahead and replace it. You've already come this far. You can get replacement washers at almost any hardware store. Sometimes you may want to replace the whole stem, especially if the handle end is stripped out. It's best to just take the stem with you to the store and see if you can match it up. Most Do It Yourself stores have replacement stems for many popular brands. If your valve has a center diverter valve to switch the waterfrom the tub spout to the shower head the same process applies. Many times it is easier to replace the diverter stem than to repair it. This really depends on the design of the stem.
OR, you can think about developing a group, where relationships prevail, your time and efforts come with great rewards, and you can multiply your efforts through helping others succeed, as they help you with introductions and referrals. So with much less time and effort, you can benefit from creating your own referral group.
The first step in the replacement project is to turn off the water line repair to the toilet and flush any water that may be in the tank. If you forget this step, you will have a giant mess to clean up! You should now disconnect that water line.
From your own point of view, it is important that the plumber be trustworthy and credible. Ensure the plumber comes with at least two strong references which you can verify. This will help you be more secure and suffer less anxiety.
Then, you can take your new shower parts home and reinstall them in the inner assembly. It is very important that everything be aligned properly and tightened to prevent leaks. Beware of over tightening, however, since this can also cause problems. Once you are sure everything is installed properly, replace the cover plate and turn the water back on to test your repair work. With a little bit of work, your do-it-yourself shower repair project can be a success. It does not take an expert, just a little effort and know how.